可以為所有測量量設置報警條件。這些包括過電流，

欠電流、中性電流、電流不平衡、電壓不平衡、相位反轉，

過頻、欠頻、功率因數、開關輸入等。報警信息包括

以簡單易懂的英文格式顯示。PQM配備了一個使用Modbus或DNP 3.0的標準RS485端口

協議。這可用于集成過程、儀表和電氣

通過將PQM儀表連接到DCS來滿足工廠自動化系統的要求

或SCADA系統。運行EnerVista PQM Setup的PC可以更改系統設定點和

監控值、狀態和報警。持續監控最大限度地減少了過程停機時間

通過立即識別由于故障或增長變化而導致的潛在問題。四個隔離的4至20 mA（或0至1 mA，取決于安裝選項）模擬輸出

可更換多達八個傳感器。輸出可以分配給任何

PLC直接接口的測量參數。

Alarm conditions can be set up for all measured quantities. These include overcurrent,

undercurrent, neutral current, current unbalance, voltage unbalance, phase reversal,

overfrequency, underfrequency, power factor, switch inputs, etc. The alarm messages are

displayed in a simple and easy to understand English format.The PQM is equipped with one standard RS485 port utilizing the Modbus or DNP 3.0

protocols. This can be used to integrate process, instrumentation, and electrical

requirements in a plant automation system by connecting PQM meters together to a DCS

or SCADA system. A PC running EnerVista PQM Setup can change system setpoints and

monitor values, status, and alarms. Continuous monitoring minimizes process downtime

by immediately identifying potential problems due to faults or changes from growth.Four isolated 4 to 20 mA (or 0 to 1 mA depending on the installed option) analog outputs

are provided that can replace up to eight transducers. The outputs can be assigned to any

measured parameters for direct interface to a PLC.