如果從INSUM設備接收到的時間戳不正確，則顯示這些字段。（參見

以下）。

為報警列表生成報警

控制器系統軟件為中的報警和事件列表生成報警

如果參數

設備上的Generate Alarms（生成警報）設置為Enabled（啟用）或Enabled Trip/Warning（啟用跳閘/警告）或

已啟用詳細信息。

如果這次從INSUM設備接收到的時間戳是正確的（有效時間）

stamp用于生成的報警消息。如果不是，系統軟件會標記

生成的報警消息與當前控制器時間。

在這種情況下，報警消息在控制器中帶有時間戳。如果這次

準確度是足夠的，這種方法可能是推薦的，因為它是

更易于配置。INSUM系統中不需要系統時鐘。如果你讓

系統軟件生成警報，可以使用INSUM給出的時間戳

設備。如果使用INSUM系統時鐘，這是一個更準確的時間

郵票

摘要報警，每個設備一個報警對象

生成警報=已啟用意味著系統軟件內部（無

需要INSUMReceive）從

INSUM設備。當從INSUM系統更新此變量時，系統

軟件對內容進行評估。

如果被分類為警報的位（一個或多個）（例如不是“Started1”位）

設置，并且之前沒有設置這樣的位，系統軟件生成一個警報

消息

如果接收到具有未設置報警分類位的變化的報警更新

再過一段時間，系統軟件就會生成警報關閉消息

these fields if the time stamp received from the INSUM device is incorrect. (See

below).

Generating Alarms for Alarm Lists

The controller system software generates alarms for the alarm and event lists in the

system, based on the updates of the INSUM alarm information if the parameter

Generate Alarms on the device is set to Enabled or Enabled Trip/Warning or

Enabled Detailed.

If the time stamp received from the INSUM device is correct (a valid time) this time

stamp is used for the generated alarm message. If it is not, the system software tags

the generated alarm message with the current controller time.

In this case, the alarm messages are time stamped in the controller. If this time

accuracy is sufficient, this method is probably to be recommended because it is

easier to configure. No System Clock is needed in the INSUM system. If you let the

system software generate the alarms it can use the time stamp given by the INSUM

devices. If the INSUM System Clock is used this is a much more accurate time

stamp.

Summary Alarms, One Alarm Object Per Device

Generate Alarms = Enabled means that the system software internally (without

needing INSUMReceive) creates a subscription of the alarm variable from the

INSUM device. When this variable is updated from the INSUM system, the system

software evaluates the content.

If a bit (one or more) which is classified as an alarm (e.g. not the bit "Started1") is

set and no such bit previously was set, the system software generates one alarm

message.

If an alarm update is received with the change that no alarm classified bits are set

any more, the system software generates the alarm-off message