菜鳥博士

運行期間出現錯誤：針/密封移動超出限制 (5.0) Needle/Seal move limit exceeded (5.0) - 中文版

故障描述

運行期間或 SM-FTN 灌注期間出現 Needle/Seal move limit exceeded (5.0)（針/密封移動超出限制 (5.0)）錯誤信息

“定義針密封”診斷測試通過，未出現問題或錯誤

環境

ACQUITY UPLC H-Class

ACQUITY UPLC I-Class

SM-FTN

原因

密封常數過低 (3 N/mm)，需要重置稱重傳感器線纜。

安裝 30 μL 針時也會出現問題，因?yàn)獒樏芊猓ㄊ褂迷撫橆^）定義會給出較低的密封常數值。針密封定義應使用缺省的 (15 μL) 針進行，然后可以更換為 30 μL 針，無需進一步定義。

解決方法

重新啟動 SM-FTN。此步驟在更換針后至關重要（在 15 μL 和 30 μL 針之間更換）。

運行“定義針密封件”診斷測試，確保密封常數接近 8-11 N/mm。

SYMPTOMS

Error message "Needle/Seal move limit exceeded (5.0)" appears during runs or during priming of SM-FTN

"Characterize Needle Seal" diagnostic passes without issue or error

ENVIRONMENT

ACQUITY UPLC H-Class

ACQUITY UPLC I-Class

SM-FTN

CAUSE

The seal constant is too low (3 N/mm). The load cell cable needs to be reset.

Needle carriage wear issue , loose belt from the needle carriage can cause this error.

Problem will occur also when 30 uL needle is fitted as the characterization of the needle seal (with that needle) will give low value of seal constant. The characterization of the needle seal shall be performed with default (15 uL) needle and then it can be replaced with 30 uL needle without further characterizations.

FIX or WORKAROUND

Power-cycle the SM-FTN. This step is crucial after needle replacement (changing between 15uL and 30uL needles).

Run the "characterize needle seal" diagnostic and ensure the seal constant is closer to 8-11 N/mm.