? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ??產品詳情資料：

如果繼電器的連接、矢量組匹配和變壓比校正正確，則以下內容適用于每相：-相電流相同高-差電流為0%-高壓和低壓側相電流的相位差為0°-同側相電流之間的相位差是120°。

模塊功能? 完全軟件可配置，無需設置模塊跳線? 單獨啟用或禁用通道? 夾緊和報警限值? 警報的鎖定? 可配置輸出偏置? 用戶定義的縮放? 高報警、低報警檢測和報告? 模塊故障報告? 可配置的保持上次狀態或輸出默認值? 支持邏輯程序中的診斷點故障觸點? 用于未來升級的閃存? 模塊狀態、現場狀態和TB指示燈? 正負變化率報警? 端子板插入或移除檢測輸出范圍電流：0至20mA，4至20mA電壓：+/-10V，0至10V背板功率要求模塊IC695ALG004內3.3V功耗時375 mA：4.9瓦GE Multilin UR8FV：7瓦熱降額GE Multilin UR8FV：無GE Multilin UR8FV：電壓模式：無電流模式：見下一頁。

? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ???產品英文詳情資料：

If the connection, vector group matching and the transformation ratio corrections of the relay are correct the following applies to each phase: - the phase currents are equally high - the differential currents are 0% - the phase differences of the HV and LV side phase currents are 0° - the phase differences between the phase currents on the same side are 120°.

Module Features ? Completely software-configurable, no module jumpers to set ? Individually enable or disable channels ? Clamping and Alarm Limits ? Latching of Alarms ? Configurable output bias ? User-defined scaling ? High alarm, low alarm detection and reporting ? Module fault reporting ? Configurable Hold Last State or Output Defaults ? Supports diagnostic point fault contacts in the logic program ? Flash memory for future upgrades ? Module Status, Field Status, and TB LEDs ? Positive and negative Rate of Change Alarms ? Terminal Block insertion or removal detection?Output Ranges Current: 0 to 20mA, 4 to 20mA Voltage: +/- 10V, 0 to 10V Backplane Power Requirements 375 mA maximum at 3.3V Power Dissipation within Module IC695ALG704: 4.9 Watts maximumGE Multilin UR8FV: 7 Watts maximum Thermal Derating GE Multilin UR8FV: NoneGE Multilin UR8FV: Voltage mode: none Current mode: See next page.