五月天青色头像情侣网名,国产亚洲av片在线观看18女人,黑人巨茎大战俄罗斯美女,扒下她的小内裤打屁股

歡迎光臨散文網 會員登陸 & 注冊

CheckCIF-CRYSS02

2020-05-04 15:05 作者:DJ_Tokyo  | 我要投稿

PROC-NAME: CRYSS02 Type_3

PURPOSE: To check that the values of _exptl_crystal_size_* are not larger than expected.

PROCEDURE:

(1) IF _exptl_crystal_size_min > 0.6 && _diffrn_radiation_type != neutron

issue ALERT B

? ? ? ?? "Alert B The value of _exptl_crystal_size_min is > 0.6"

(2) IF _exptl_crystal_size_mid > 0.8 && _diffrn_radiation_type != neutron

issue ALERT B

? ? ? ?? "Alert B The value of _exptl_crystal_size_mid is > 0.8"

(3) IF _exptl_crystal_size_max > 1.0 && _diffrn_radiation_type != neutron

issue ALERT B

? ? ? ?? "Alert B The value of _exptl_crystal_size_max is > 1.0"

? ? ? The crystal must be smaller than size of the incident beam at the crystal. For most diffractometers with fine-focus X-ray tubes and monochromated radiation, this size is unlikely to be much greater than 0.5 mm. Note that increasing the collimator diameter will not necessarily increase the size of the incident beam at the crystal. If the crystal used in the data collection is larger than the incident beam, then unpredictable errors in intensities will occur due to the varying amounts of the crystal in the beam for different reflection positions.?If you obtain an alert about crystal size, then data should be collected with a smaller crystal. For the above reasons, it is recommended that crystals be generally smaller than 0.5 mm along any edge.

? ? ? If you used neutrons and obtained an alert about the crystal size, then you have forgotten to set _diffrn_radiation_type 'neutron'.

(http://journals.iucr.org/services/cif/checking/CRYSS_02.html)

目的:檢查_(kāi)exptl_crystal_size_*的值是否超出預期。

過程

(1)_exptl_crystal_size_min > 0.6且_diffrn_radiation_type不為neutron

則發布B級警告

? ? ? ?? "Alert B The value of _exptl_crystal_size_min is > 0.6"

(2)_exptl_crystal_size_mid > 0.8且_diffrn_radiation_type 不為 neutron

則發布B級警告

? ? ? ? ?"Alert B The value of _exptl_crystal_size_mid is > 0.8"

(3)_exptl_crystal_size_max > 1.0且_diffrn_radiation_type不為neutron

則發布B級警告

? ? ? ?? "Alert B The value of _exptl_crystal_size_max is > 1.0"

? ? ? ? 晶體必須小于晶體上入射光束的大小。對于大多數具有精細聚焦X射線管和單色輻射的衍射儀,該尺寸不太可能遠大于0.5 mm。注意,增加準直器直徑不一定會增加晶體處入射光束的尺寸。若數據收集中使用的晶體大于入射光束,則由于光束中不同衍射位置的晶體數量的變化,強度上會發生不可預測的誤差。若出現關于晶體尺寸的警告,則應當使用較小的晶體收集數據。由于上述原因,建議晶體的任何邊緣通常小于0.5 mm。

? ? ? ? 若你使用中子衍射收集數據的數據出現晶體尺寸警告,那么想必你是忘了將_diffrn_radiation_type設為“neutron”。

警告原因:晶體尺寸超出限制大小。

解決策略:將晶體尺寸改為合適的數值。


CheckCIF-CRYSS02的評論 (共 條)

分享到微博請遵守國家法律
龙胜| 甘肃省| 昂仁县| 孟州市| 咸阳市| 临江市| 万年县| 灵川县| 华蓥市| 普安县| 通渭县| 饶河县| 绥棱县| 兴城市| 清水河县| 铁岭县| 新巴尔虎右旗| 鹤壁市| 安远县| 上高县| 建昌县| 本溪市| 普兰店市| 永年县| 大方县| 西充县| 南江县| 延庆县| 溧阳市| 房山区| 施秉县| 芦山县| 常德市| 乐平市| 常州市| 石景山区| 得荣县| 木兰县| 红河县| 芜湖县| 手游|